Materials Required:
* A Plate
* Camel texture white
* Camel Acrylic gloss medium
* A design
* Carbon paper
* Pencil
* Oil Paints
* Brushes
Procedure :
1. Take the plate and clean it well.
2. Trace the design on to the plate using a carbon paper.
3. Give the outline of the design using a cone filled with Camel texture white.
4. Wait till the outline dries.
5. Now paint the design with oil paints
. Choose colours according to your taste.
6. It takes 2-3 days to dry.
7. After drying apply camel acrylic gloss medium onto the plate. It gives a glossy finish to the painting and also helps it to last long.
Your ceramic painting is ready.
To make a cone:
Take a thick plastic cover or sheet, roll it in the shape of a cone and stick the edges. Fill the paste inside the cone and close it sticking the ends tightly. Make a small hole with a pin at the tip of the cone. The fine paste can be squeezed out in a thin strand. This can be used to give the out line of the design in the plate
Ceramic painting VEDIO CLIPING
Tuesday, August 03, 2010
Sunday, August 01, 2010
GLASS PAINTING
FIRST LEVEL PAINTING
1.Get the piece of glass and the painting kit, clean the glass so as to get a smooth surface.
2. If you are not going to oven cure your finished painting then you need somewhat rough surface. Firing in a kiln can help oil paints dry and adhere better otherwise paints tend to peel or chip off. This can be countered by roughening up the surface a little with wet or dry sandpaper. Roughing the surface in this manner will help the paint adhere better and last longer.
3. Select a pattern which has clear outlines with minimum possible curves and pointed corners.
4. Trace the pattern on a piece of paper which is exactly the size of the glass piece. The pattern should be drawn exactly at the center with at least 1 or 1-1/2 inches margin on all sides.
5. Keep the glass on the patterned piece of paper aligning them perfectly.
6. Make outlines of the pattern on the glass with the help of glass liner. Use black glass liner for maximum clarity. These borders help in holding the wet colors within them and avoid spilling of the paints.
7. While doing all these, be careful not to mess up the pattern. If, however, it happens, swab the smudged part with cotton-wool dipped into nail polish remover and wipe away with piece of cloth.
8. Leave the pattern to dry up. It may take anywhere from 2 to 5 hours to get completely dried. It can also be blow dried or quickening the process.
9. Now use the colors to fill in the pattern with uni-directional strokes. Avoid taking too much of paint or spilling it. Any corner or part that is not painted can be seen from the reverse side by lifting up the glass. Be careful, not to hold the glass vertically to avoid dripping off the colors.
10. If any bubbles are made in the colors while painting, then pierce them with needle or a pin. They can also be gently brushed towards the outlines bringing them out of the borers and then wiping them away with nail polish remover.
11. Avoid applying two coats of paint in any portion of the pattern.
12. Allow the painting to dry for at least 24 hours.
13. After the painting has dried, place it in a cold oven. Set the oven to 160 deg C (325F). When temperature reaches 160C, time it for 40 minutes. Switch off the oven and allow it to cool. Once the oven is cold, remove the Glass Painting.
14. Alternatively, you can let the painting air dry only by not klin firing it.
15. You can use beads, glitter, and sequins into the wet paint before it dries for decorating the painting.
Not only paintings, this method, with little changes, can be used to make a painted stain glass window or mirror. You can even make glass painting greeting card and use it on any special occasion.
Not only paintings, this method, with little changes, can be used to make a painted stain glass window or mirror. You can even make glass painting greeting card and use it on any special occasion.
Subscribe to:
Posts (Atom)